![]() It’s often a good idea to inspect hops with packet loss. If PingPlotter’s packets couldn’t make it, there’s a good chance your other ones couldn’t, either. When you see a red bar, it means, at some point during testing, PingPlotter was unable to reach that hop. The former 2 addresses are League of Legends EU-West targets. Im currently running pingplotters on 3 targets: 185.40.65.1, 162.249.72.1 and . Usage: python main.py -h -H HOST -i INTERVAL -l LIMIT -t TIMEOUT Plots a real-time graph of ping latency. When my latency isnt affected by the 2nd, 3rd or 4th hops it barely increases at all the entire way. ![]() The percentage of lost packets over the current focus period is indicated by a horizontal red bar. The high ping then carries down to the rest the addresses until it hits its destination. If the high end of your latency range is dipping into the red, you should give the offending hops a closer look. The range of latency values for each hop in your current focus period is shown as a horizontal gray bar. On the Latency Graph, the average latency of each hop is shown as a red circle. Monitor hundreds of local connections and capture the data needed to identify the source of problems and prove it to others. As the data collects, you can begin looking at the Data Table and Latency Graph to find patterns of high latency and packet loss. PingPlotter Professional is a network diagnostic tool for engineers, sysadmins, and other people with above-average tech skills. The Trace Graph gives you a bird’s-eye view of your collected PingPlotter data. It can run in the background collecting data while you continue to run applications and then allow you to quickly look at. The percent of lost packets over the current focus period. PingPlotter is a lightweight network monitoring and troubleshooting tool. The range of latency values for each hop in your current focus period is shown. This shows the total time it takes to send a packet from your device to the target and back.Ī color-coded representation of latency, as defined by the Graph Color Legend in the Target Bar. On the Latency Graph, the average latency of each hop is shown as a red circle. The percent of lost packets over the current focus period.Ī simplified set of data for the target of your trace. If you see “ERR,” the last packet sent was lost (poor little buddy). The response time for the last packet sent. Once you make it to the server at hop 16, not only is your latency still way up there, but you're getting 9 to 10 packet loss. The fastest ping response time for your current focus period. All the sudden your latency goes up to 400+ms at hop 15. This average ignores timeouts and lost packets. The average ping response time for the current focus period. ![]() If this is blank, it means the router/server/hamster wheel doesn’t have a DNS name or doesn’t like the packet type currently being used. The number of packets sent during the current focus period. A graph icon shows which hops have a Timeline Graph open (more on that later). A circle denotes an active hop and is color-coded to show latency based on the Graph Color Legend. This lists the order of hops between you and your target.
0 Comments
Leave a Reply. |